General Store BD

EasyDriver Shield Stepper Motor Driver V44 A3967 For Arduino

৳ 330

Availability: 30 in stock

SKU: Shield-007 Categories: , ,


The EasyDriver is a simple to use stepper motor driver, compatible with anything that can output a digital 0 to 5V pulse (or 0 to 3.3V pulse if you solder SJ2 closed on the EasyDriver).

It requires a 7V to 30V supply to power the motor and can power any voltage of stepper motor.

The EasyDriver has an on board voltage regulator for the digital interface that can be set to 5V or 3.3V. Connect a 4-wire stepper motor and a microcontroller and you’ve got precision motor control

The item drives bi-polar motors, and motors wired as bi-polar. I.e. 4,6, or 8 wire stepper motors. On this version (v4.4) we fixed the silk error on the min/max adjustment.

It provides much more flexibility and control over your stepper motor, when compared to older versions.

The microstep select (MS1 and MS2) pins of the A3967 are broken out allowing adjustments to the microstepping resolution. The sleep and enable pins are also broken out for further control.

Note: Do not connect or disconnect a motor while the driver is energized. This will cause permanent damage to the A3967 IC


A3967 microstepping driver

MS1 and MS2 pins broken out to change microstepping resolution to full, half, quarter and eighth steps (defaults to eighth)

Compatible with 4, 6, and 8 wire stepper motors of any voltage

Adjustable current control from 150mA/phase to 750mA/phase

Power supply range from 7V to 30V. The higher the voltage, the higher the torque at high speeds

Package Included:

1 X A3967 EasyDriver Shields


There are no reviews yet.

Be the first to review “EasyDriver Shield Stepper Motor Driver V44 A3967 For Arduino”

Your email address will not be published. Required fields are marked *